More 3D printed Guyver

I’ve (not so) recently been working on these two Papsikel’s 3D printed models. They are from the same line as the previously shown Guyver miniatures. As you can see these miniatures are fairly beefy, clocking in at 4.5cm when based.

For the blue one (called Vamore in the show I believe), I reused the stippling technique from the infinity lizard tag to get a road asphalt look. Rather than free handing the yellow lines like I did last time, I applied a thick dollop of yellow paint to a pallete and dipped a wooden coffee stirrer in to the paint and just pressed this against the base to transfer the paint in a straight line.

For the red one (Gaster) I used GW sand and -perhaps controversially- decided not to paint the sand, but to leave it as its natural colour. Overall not to happy with the choice of red on Gaster here, but I like the muscle striation effect well enough.